Hood clearance can be adjusted. The assembly of the hood gap will cause the vehicle to vibrate greatly, which will affect the aesthetic effect of the whole vehicle. Moreover, the large hood gap will also cause rainwater to leak into the engine and endanger the start-up operation. The solution to the engine hood clearance is as follows:
1. There is a black rubber pier on the left and right of the water tank frame behind the middle net, which is used to resist the machine cover. Turn the black rubber pier left and right by hand to adjust the gap between the machine cover and the middle net;
2. Open the engine hood. There are three screws on the left and right sides to fix the fender, one at the rear of the headlight, one under the innermost sponge of the hood and one in the middle. Loosen these three screws to pull the fender outward a little, and tighten the screws when the hood is not wide;
There are two plastic blocks on the cover. There are two in front of the car. Soft plastic can be rotated to the end. There are two U-shaped tongues on the left and right sides of the hood. Take off the upper plastic clip and adjust it on the right side. Million car purchase subsidy