Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and beauty - What can you do with one punch?
What can you do with one punch?
Stamping is mainly classified according to process, which can be divided into two categories: separation process and forming process. The separation process, also known as blanking, aims to separate the stamping parts from the sheet along a certain contour line and ensure the quality requirements of the separated section. The purpose of forming process is to make the sheet metal plastically deform and make the workpiece have the required shape and size without destroying the blank.

In actual production, a workpiece often goes through multiple processes. Stamping, bending, shearing, stretching, bulging, spinning and straightening are the main stamping processes.

Extended data

Safety equipment/devices

1. Stamping equipment shall have nameplate, various operating instructions and safety and warning instructions.

2, power wiring should be standardized, the cable of the equipment should not be damaged, to prevent aging.

3. The door lock of the distribution box on the stamping equipment should be equipped with a key, which will automatically cut off the power supply when opening the door.

4, single, continuous, pedal stamping and other operations should be used with a key lock switch.

5. When the stamping equipment runs in a single stroke, there shall be no continuous stamping stroke.

6. When continuous stroke operation is selected, there should be a pre-control action link in the operation process.

7, stamping equipment must have an emergency stop button, and should be able to self-lock.

8. There should be interlocking control between pedal operation and manual operation.

9. The transmission parts such as transmission gears, pulleys, flywheels and levers exposed outside the fuselage and at the top of the fuselage shall be equipped with protective covers.

10. Pedal device is pedal type, controlled by electric switch, and can be automatically reset.