In ET typesetting system, the typesetting steps for defining the alignment points of horizontal and vertical bars are as follows:
Step 1: After all the pieces defining the alignment points are expanded (especially the alignment points must be expanded and are commonly used grading points), return to the interface points of the typesetting system "Typing"/"Alignment Grid"/select and define the horizontal alignment points;
Step 2: Determine the general central cutting piece (such as the front piece or the back piece), and select the back piece as the central cutting piece, as shown below. 1 Right-click, then click the left mouse button and click "Point 2", "Point 3", "Point 4" and "Point 5" as shown below to determine the alignment point of the big body bar;
Step 3: Determine the alignment point between the sleeve and the big body, as shown in the following figure. Click "Point 1" with the left key of small sleeve, then right click, and then click "Point 2" and "Point 3" with the left key of mouse to determine the alignment point of the stripes on the big and small sleeves.
Step 4: Determine the vertical alignment point of the back collar, select "Define vertical alignment point", click "point 1" of the back collar, then click "point 2", "point 3" and "point 4" with the left mouse button respectively to determine the vertical alignment point of the back collar and the big body, and then save it directly. Never go to the "grading interface" to expand again! !
Step 5: Enter the "marking system", set the width of horizontal and vertical grids according to the actual fabric, then select the grid style suitable for the fabric, set the stripe style and the corresponding size, and manually arrange the marking frames. There is no automatic marking! At this time, each code and the alignment point of each chess piece will automatically get the grid line.