A better way to eliminate the vulcanization of storage battery is to use pulse repair method. When maintaining the battery, the instantaneous voltage of the pulse is generally determined according to the functional needs of the product. The instantaneous voltage used is between 60 V and 300 V. For example, the pulse voltage value of products used to prolong battery life should not be too large, especially the pulse voltage value of battery repair products can be too large (if the pulse voltage value is too large, it will cause damage to battery plates).
High pulse voltage and short battery repair time. When the pulse voltage is low, the battery repair time is relatively long. Although the pulse instantaneous voltage is very high, the average voltage is not high, which is harmless to human body and very safe.
Battery repair method and technology
Strong current repair method is a method to repair the storage battery with high voltage or high current during charging, which is often used when the effect of pulse repair method is not obvious. High-voltage repair method, which mainly uses the charging voltage of 1.3- 1.5 times the nominal voltage of the battery to repair the battery. For example, when the charging current is constant or close, charge a 36V battery with a 48V charger. The charging time should be measured and not too long, otherwise the battery will heat up due to gas escape.
Full-charge-discharge repair method is a method to repair the battery by fully charging the battery and then fully discharging it. Full charge and full discharge repair method is mainly used to repair slightly damaged batteries. At the same time, this method can effectively activate active substances in the deep layer of batteries and improve the capacity of batteries.