Two or four strokes of wire rope insertion operation:

Wire rope 24-head method: the first stroke presses two to choose four, the second stroke presses three to choose three (the oil pit is pressed down), the third stroke presses four to choose two, the fourth step presses five to choose one, (the first four strokes are in the same space and out in different spaces), and the fifth stroke and the fourth stroke press one to choose two.

closing method: close 246, throw away the first root, insert the second root normally (press one to choose two), throw away the third root, press the fourth root to choose two (that is, the entry of 2 is the exit of 4), throw away the fifth root, and press the sixth root to choose two (that is, the entry of 4 is the exit of 6). Note: the direction of insertion is forward insertion, and never reverse insertion.

related content explanation

1? After five times of penetration, the plug joint is made, and the five times of penetration can be composed of three times of whole strand penetration and two times of reduced strand penetration. All connectors should be opposite to the twist direction of wire rope; Except for the first group, the tail ends of all strands inserted in other groups should be opposite to the twist direction of the wire rope.

2 ? Interpolation should be carried out in a way of one share up and one share down. ?

3 ? If the wire rope has a fiber core, the core should be completely penetrated with the first end of the first group, and then the exposed core should be cut off. If the strand has a fiber core, the strand core should remain in the original strand. ?

4 ? If the wire rope has an independent wire core, the core should be divided into three parts, namely:? -two stocks; ? -two stocks; ? -two stocks plus its core. ? These three parts are inserted with three staggered tail ends, and only pass through three complete insertion points. ?

5 ? If the wire rope has an independent wire strand core, this core should be folded inward when the first group is inserted, and then completely inserted into the center of the insertion head five times. ?

6 ? All interpenetration shall be firmly tightened until it is consistent with the center line of the inserted wire rope. In order to make the inserted parts smooth and round, appropriate tools should be used to shape them so that they can enter the appropriate position.