1, time. Generally, it is planted after the autumn bamboo shoots mature in September-165438+10 or before the spring bamboo shoots germinate in February-March. 2. Density. The planting density is 3m× 4m, and 55-60 plants are planted per mu. 3. Planting techniques. Digging planting holes in the soil: pulling wires at regular intervals, digging planting holes with a depth of 80cm and a width of 80cm, then pressing green manure with a depth of 50cm, and backfilling the soil with a height of 40cm for planting; Ridge planting: 8 meters, 60-80㎝ wide and 40-60cm deep, with 2 ridges per grid (width 1.5m, center distance 4m, height 20-30cm). When planting, the roots of seedlings should be trimmed appropriately, placed in the center of the planting hole, stretched and righted, and the seedlings should be gently lifted upward while filling the soil, so that the roots are closely connected with the soil. Water the roots, make a 1m tree tray around the seedlings, and cover it with chaff. 1 principle. Adjust measures to local conditions, prune trees, properly raise and lower them, and ventilate and transmit light to achieve three-dimensional effect. 2, plastic surgery (natural and happy appearance). The trunk is 20-40cm high, and the trunk branches (3-4 branches) are scattered on the trunk. The branching angle of the main branch is 30-50 degrees, and 2-3 auxiliary main branches are left on each main branch. Generally, after the third main branch is formed, the central trunk of this kind is cut off and twisted to one side to form a fruiting branch group. Step 3 trim. (1) Young trees: mainly light pruning. After selecting the extension branches of the class center and the main branches and the extension branches of the auxiliary main branches, moderate or even severe pruning is carried out, and the growth balance among the main branches is adjusted according to the pruning degree and the direction of cutting buds. In addition to properly thinning the over-dense branches, the inner branches and weaker branches in the middle and lower part of the crown should generally be retained. (2) Initial fruiting stage: continue to select short cutting to treat the trunk extension branches at all levels, erase the summer shoots, and promote the autumn shoots to be robust. In autumn, measures such as ring cutting, root cutting and water control are taken to promote the flowering of Wangshu. (3) Full-fruiting period: the fruiting branches, falling branches and declining branches are retracted in time, and the light-blocking branches, dead branches and insect branches are cut off.