2. Then the two lines cross, as shown in the figure below.

3. Then repeat the fast knot twice to make it tighter.

4. Pull the thread end into the hole of the first bead on your rope, which can not only prevent the knot from loosening, but also be beautiful.

Finally, arrange the distance between the beads to make them even and beautiful until the thread ends are out of sight.

Extended data

Maintenance requirements:

First, don't wear other metal ornaments at the same time when wearing a bead bracelet to avoid collision and deformation.

Second, avoid contact with water vapor and chemicals, and don't wear bathing suits, especially in seawater.

Third, if you have enough time, clean it with cotton after wearing it every day and put it in a jewelry box for preservation.

Four, beads bracelet because of wearing dust, you can use a soft brush dipped in toothpaste to scrub, after washing, you can use cotton cloth to dry.

Five, the maintenance of beads bracelets should always touch the jewelry with your hands, which will enhance the luster of the bracelet.

6. You'd better take it off when washing your hands. Soap contains alkaline substances, which will damage the beads and affect the luster.

7. Be careful not to touch acidic or alkaline substances to avoid cosmetics being contaminated by beads.

Eight, wear bracelets in order, first, then wear bracelets to avoid hooking clothes when wearing, causing beads to fall off.

Nine, carry a small jewelry bag with you, to avoid taking off the bracelet and putting it on the sink because of washing your hands, and accidentally falling to the ground and breaking it.