When the washing machine is working, it makes a lot of noise. Generally, the bearing is broken, so it needs to be replaced. The following methods can be adopted to replace the drawstring:

1. Open the rear cover plate and remove the belt. Dismantling the belt is very simple. Lever the belt outward with a screwdriver, and turn the pulley gently with your hand, and the belt will automatically fall off.

2. Remove the top cover plate. After one screw is removed from the left and right of the back, the whole plate can be pushed from front to back. See the round screw bayonet in front of the figure.

3. Remove the cement block, the control panel and the box for washing powder, and remove the visible screws and all components.

4. Remove the four screws on the bottom seat. This is the screw under the fixed roller. Remove it to facilitate the roller to be taken out.

5、? Remove the plastic ring clamp of the front roller, remove the screw and pull out an iron wire to complete the work.

6. Take out the drum. There are no screws on the left and right spring hooks. After removing the cement blocks on it, take out the hooks and lift the drum out.

7. Remove the front cover of the drum. Don't move the places marked with red arrows in the figure.

8. Take out the inner barrel. The bearing of the washer is installed on the outer barrel. * * * There is a sealing ring, a bearing on the inner side and a bearing on the outer side of the three fittings.

9. Next, the bearing can be replaced. During installation, pay special attention to the fact that the bearing cannot be hammered in.