Preparation tools: two ribbons.

1. Fold the two ends of the tape like this, with the left side down and the right side up.

2. Fold the lower right half, press up two thirds, and press the thumb at the intersection.

3. The left hand passes through the lower left belt from the inside.

4. Bypass the central intersection and fold under the folding in step 2 just now.

5. Hold the center point and the right folded part with your left hand, poke the left folded part out of the hole with your index finger or middle finger, and grab it with your right hand and pull it out.

6. Adjust the length and tighten it. Well, such a simple bow came out.

How to tie a bow

Preparation materials: ribbons.

1, put ribbons on the index finger, middle finger and ring finger.

2, the other end around three fingers, thumb down.

3. Circle around three fingers.

You need to press the belt under the main pipe with four fingers.

5. Wrap the ribbon below twice.

6. At the beginning, insert four fingers into the middle this time, and pull out the lead wire between two fingers as if the fingers were entangled in the past.

7. Then take out the original ribbon from the place where two fingers are holding the ribbon.

8. After finishing from the finger, it is like this. We need to cut off his tail.

9. Cut an oblique triangle from the outside to the inside with scissors.

10, tie a beautiful bow, it's simple.