The knotting method of the elastic thread of the bracelet is as follows: To tie the elastic rope bracelet, the rope needs to be folded in half twice, and the fishing line is folded in half after passing through the elastic rope, and the beads are taken out to tie the fishing line into one. After the largest hole bead is inserted into the elastic rope, the other beads are inserted one by one, and the ends of four threads are taken out, two of which pass through the coil at the other end. Finally, tighten the rope until all the beads are together, tie the knot twice and cut off the excess rope.

The specific steps are as follows:

1. Prepare elastic thread, scissors and fishing line.

2. Then take a slightly longer elastic thread, fold it in half twice, and then fold it with a fishing line through the elastic thread.

3. Next, take out the beads and make a line. Don't tie all the beads in a hurry, put them on your wrist and measure their length first. If appropriate, put both sides of the elastic thread into the elastic thread folding ring respectively, so that the knot will be stronger.

4. Then start wearing beads in the correct order.

5. Note here: put one bead with a larger hole.

6. Wear all the beads in order.

7. At this point, take out the ends of the four wires and thread two of them through the coil at the other end.

8. Then tighten the thread, and tie a knot after all the beads are tightened. It's best to tie a fast knot twice.

9. Finally, cut off the remaining fishing line with scissors after knotting, and pay attention to leaving a little line to prevent the line from breaking free because it is too short.