I am a user of Ke Mei board machine, and I will never be. I threw away the machine. So I'm not afraid to offend manufacturers. Before buying board machine, I collected comments from several manufacturers online. Is nothing more than a comparison between Ke Mei, Oak and Zhuo Yue. Aoke board machine is the most expensive, and there are many bad word-of-mouth problems on the Internet (now I believe many comments are attacked by Ke Mei company). You board machine is the cheapest, but it can only cut right angles, and its online reputation is not good (Ke Mei writers really admire it, so their competitors have become ghosts in their works). Only Ke Mei company is the best, including cowhide, which is better than imported ones (hahaha). Why didn't ks, the first brand of cross stitch, take the equipment from you? Under the promotion of their contacts and salesmen, I directly clicked on Excellence and Aoke. 4 1000 yuan for door-to-door installation, and I made a deposit, dreaming that one day I could finally compete with ks's mounting skills. On the day the machine arrived at the store, technicians from Ke Mei also came to the store for installation training, which lasted for three days (wasting more than N pieces of paper). Oh, dear, I'm not familiar with the operation. Oh, my God, it's okay. The technology tells me that it will be very skilled to operate slowly for a few days. I don't want to delay others. The balance has been settled. . . . . . . However, many problems follow. The first blade is not durable enough to cut 2-3 patterns, so its burr is very serious. Replace the blade immediately. (Very inefficient) Second, cutting gold cards (that is, using film and cardboard) is easy to cause burrs or cut gold cards. Third, I can't cut a lot of Jintong, Tian Li and new concept cardboard. I don't know why, cutting these cardboard is particularly easy to rot. If I cut peony cardboard, I will definitely buy a lot of cost-effective cardboard for several years. But Ke Mei's machine only recognizes peonies. It's amazing. Just like a dutiful son stuck in a peony paper, he only recognizes one father. Fourthly, when cutting arc patterns, the cutting is irregular and unsmooth, which is easy to produce burrs. Fifth, isn't it a 45-degree oblique paper jam? How to adjust 55 degrees or degrees to cut? Because 45-degree cutting is very harmful, if the blade can't cut out the pattern, it should be replaced. Cutting 55/60 degree cardboard can barely cut three patterns. But the three-dimensional sense is much worse than 45 degrees, and it is not much better than the right angle of the mold. The sixth most embarrassing thing is the operating system. It may be due to technical reasons that the operation is extremely complicated (more than 0/0 times more difficult than manual gear shifting/kloc-0), and it is not as simple and flexible as Aoke board machine's own system, nor as simple and flexible as board machine's fool operation. There are nearly 30 mounting shops in my street, including two Ke Mei (including me) cardboard machines, one Aoke and one Zhuoyue. Their machines work normally and are efficient. But it happened that the best Ke Mei advertised on the Internet made people angry. I called the manufacturer and said that others wouldn't do it and that I wouldn't operate it. But after three months, my efficiency is still the same. I'm not far from the other side of the street. Now my business is much better and my efficiency is much faster than mine. The other company bought Aoke, and the effect is at least similar to ks, and the efficiency is acceptable. The junk equipment I bought was really just a waste of paper and time, and my confidence was almost destroyed. Well, we can only handle it at a low price. I will continue to use the mold I bought before. I lost to you at Ke Mei Company.