1, the cut branches must be properly treated before they can be cut into soil or water. You can remove all the leaves at the bottom of the branch and leave only two at the top. Many leaves will consume too much water, which is not conducive to the rooting of branches.

2. There is another key point. If the leaf surface is too large, you need to cut off about half of the leaves, such as the common hydrangea. In addition to removing the leaves at the bottom, the top two leaves should also be cut off by about 2/3.

3. When cutting branches, you can dip a little rooting powder first, which helps to promote rooting and prevent branches from rotting. Has the functions of sterilization and disinfection.

4. If it is rooting liquid, you should soak the branches in it. After two or three hours, take it out and cut it in water, and continue to take root in hydroponics. If there is no rooting powder, honey can be used instead. Do not directly soak the branches in honey, but mix the honey with water before use, and then soak the branches in it after stirring evenly. After about 6 hours, it can be taken out for cutting propagation.

5. Before cutting branches, the soil can be watered and wetted, and the soil can be mixed with peat soil and perlite in a ratio of 3:2. When cutting branches in the soil, you can spray water slightly to keep them moist, and the humidity of the surrounding air should be kept between 55% and 65%. The pruning environment should be ventilated and transparent, and avoid being placed in a closed space. You can give a little soft scattered light in the morning or at night.