Current location - Plastic Surgery and Aesthetics Network - Wedding planning company - Playing method of ribbon multilayer bow
Playing method of ribbon multilayer bow
Get enough ribbons and scissors ready for use, cut off the corners at both ends of the ribbon and tie it in a circle, then tie the ribbon on the tied circle, pinch the center of the circle, then cut off the extra bows and cut out the same corners at the ends of both sides. Tie three bows with different ribbons, cut off the extra ribbons, and add a bow with a ribbon that can highlight the layering.

The first step of ribbon multi-layer bow play is to prepare the required materials, ribbons and scissors of the required length. The length of the ribbon should be long enough to wrap the placed items and leave a small bow. Step 2, cut two corners with the same length at the end of the ribbon. Step 3: Cut out the ribbon with the same length as the first paragraph, and then repeat it for 3-4 times. After the cycle is completed, grasp the center of the cycle. The effect is shown below.

Step four, tie the curly ribbon in the middle of the knotting ring and tie the bow to the articles used. In this process, you should pinch the ring with your fingers until the ribbon can be wrapped and tied tightly. Then tie a bow, cut off the extra ribbon and cut both ends at the same angle. In addition, you need to leave a long section at the end of the curly ribbon, because for the next step, you need to use it to add layering to the bow, and the effect is as shown below.

Step five, tie three bows with different ribbons, cut off the extra ribbons and cut off the corners at both ends. Step 6, tie the second bow with a curly ribbon in the middle of the previous bow. Finally, add a third bow with a ribbon or string to highlight the layering. Repeat the looping method in the third and fourth steps again, and the multi-level ribbon bow game will be completed.