The method of making roses by hand:
1: small flower bud method: each flower bud needs 3 petals. First, take 22# iron wire and stick double-sided tape on it, roll it into an olive roll with a cotton swab about 2 cm in diameter, roll it with a white patch, then scrape three petals on both sides, put it into the finished olive roll by inverted fan-shaped sticking method, and tie the bottom with 32# iron wire.
2. The tied bud must be wrapped in cotton paper, but the base needs to be thicker. Finally, scrape the tip of the calyx and paste it with a patch. Big flower practice: take three petals from the prepared small bud and stick them around in a fan shape, tie them at the base with 32# iron wire, remove three petals and tie them at three angles, and finally wind the remaining six petals on the outer ring in series to make it a flower.
3. Leaves: First tie up each leaf, then put the big leaf in the middle, and then roll up four small leaves, as shown in the figure, to form a group.
The assembled leaves are grouped and rolled on the finished flowers.