Step 2: weave four strands with one end of the thread, and the four strands can be 60-80cm, depending on the size of the head circumference;
Step 3: thread one end of the four strands into the hole of the pendant, then align the two ends of the four strands, take these two groups of strands as the axis, and then take 50cm 7 1 strands and tie diagonal knots on them respectively. Note that the front of the pendant is consistent with the front of this oblique knot;
Step 4: Fold the two turns back and tie a diagonal knot;
Step 5, cross the two winding wires and tie a diagonal knot on the shaft respectively;
Step 6: Pull the winding down to make a shaft, and three of the four shafts make oblique knots, the left and right sides are the same;
Step 7: Thread two threads without oblique knots together to form a small gold ball of 1 3mm, and then tie oblique knots on the left and right shafts respectively. The last two shafts form an oblique knot;
Step 8: Pull the top one down to make a shaft, and the other lines are made into oblique knots, the left and right sides are the same, and the last two shafts are made into oblique knots, and all the redundant lines are cut off and glued;
Step 9: Take 1 and cut off the remaining thread ends to make a circle, then take 1 and tie a flat knot on the circle;
Step 10: After tying about 9 flat knots, cut off 2 winding wires and burn them;
Step 11: Pull down the flat knot ring and put it on the four-strand braid;
Step 12: the flat knot loop is minimized, and it can be pushed on four strands, and the extra two strands are cut and burned.