1. Light one end of the pendant perforated rope with a lighter, quickly twist it into a wiredrawing shape by hand (as shown in the figure), and then cut off the excess part of the rope end with scissors.
2. Pass two pendant ropes through the back of the pendant (as shown in the figure), and reserve the distance between the pendant hole and the knot at about 1cm (the length can be reserved according to your actual needs).
3. Put the 1 rope on the two front-end ropes, and the No.2 rope bypasses the 1 rope from above, then bypasses the two front-end ropes from below and passes through the 1 rope loop.
4. After threading as shown in Figure 4, tighten the two ropes (as shown in the small part of Figure 4).
5. Put the rope 1 on the top of the two front-end ropes, and the rope No.2 bypasses the top of the rope 1, then bypasses the bottom of the two front-end ropes, and passes through the rope loop 1 (Figures 5 and 6).
6. As shown in the figure.
7. After completing the steps in Figure 6, tighten the two ropes of the pendant to obtain the pendant rope shown in Figure 7.
8. Repeat step 1-7 three times to get the farewell as shown in Figure 8. The knotting method here can also be repeated as needed.
9. Cut off the excess rope with scissors, then burn the rope mouth with a lighter and press the rope mouth. At this point, the delivery of the lifting rope is completed.