1, first determine the length to be installed, and then take an integer to intercept.

Because this light band is a unit of 1 m, it will not affect the circuit only if it is cut off from the incision. If you cut it off at will, a unit will not light up.

For example, if a length of 7.5 meters is needed, the light strip will be cut 8 meters.

2: Connect the plug

The LED itself is a diode, which is driven by direct current, so it has positive and negative poles. If the positive and negative poles are reversed, they will be in an insulated state and the light strip will not light up.

If the connecting plug is not energized, just remove the other end of the light strip.

3. Placement of light strips

The light strip is packed in trays, and the newly removed light strip will be distorted and difficult to install. You can tidy it up first and put it in the light trough. Because the light strip is single-sided, uneven placement will lead to uneven light and shade, especially at the corner.

4. At present, there is a clip specially used to install the light bar in the light trough, called the light bar companion, which will greatly improve the installation speed and effect after use.