Both the set and the characters in the original film are dark and opaque.
How did ps bring out a small fresh tone? Schematic diagram of basic steps:
Step 1: adjust the light ratio and expose black, white and gray.
Step 2: Adjust the color temperature (beginners can use the white balance tool. Third in the upper left corner) and adjust the saturation (natural saturation and blue primary color).
The third step: the use of complementary colors (yellow highlights and blue dark parts, blue cyan and orange)
Step 4: Adjust the color of the details in the photo (such as skin color, grass, sky, water and other colors). Novices can use target recognition tools to make adjustments.
Fifth: the gradient filter tool darkens the over-bright water surface and skirt, and the brush tool adjusts the over-dark skin. )
Patch liquefaction-complete.
How to color with ps? Introduction of six common color matching methods for PS
1, curve: the menu bar "Image-Adjustment-Curve" opens the dialog box, which is used to adjust the brightness of the image. Drag the mouse on the curve and a control point will appear. Drag the control point to the upper left corner to brighten the image. Drag the control point to the lower right corner to darken the image.
2. Color Scale: the menu bar "Image-Adjust-Color Scale" command, which is used to adjust images with relatively concentrated brightness values.
The color scale of an image ranges from 0 to 255 according to brightness from dark to bright. In some images, the dark part should not be dark, the bright part should not be bright, and the brightness is relatively concentrated, giving people a gray feeling. Through the color scale, darken the parts that should be dark and brighten the parts that should be bright.
In the Level dialog box below, the commonly used adjustment range of Input Level is indicated by a red horizontal line. Drag the triangle sliders on the left and right to the beginning of the color scale density area. The triangle slider in the middle moves to the left to brighten the image, and moves to the right to darken the image.
The following figure shows that the dark color scale is stretched to 0 and the bright color scale is stretched to 255.
3. Brightness contrast: the menu bar "Image-Adjustment-Brightness Contrast" can open the dialog box. Contrast is commonly used in this dialog box, while curve function is usually used to adjust image brightness.
Improving the contrast can make the image more vivid and highlight the theme, but it may also overexpose the bright parts, so adjust the contrast according to the photos.
4. Color balance: the menu bar "Image-Adjustment-Color Balance" opens the dialog box. The Color Balance dialog box is used to correct the color cast of photos. If the image is blue, drag the slider to yellow, if the image is red, move the slider to cyan.
5. Dark Highlight: The menu bar "Image-Adjustment-Dark Highlight" opens the dialog box. Here, it is mainly used to brighten the darker parts of the image, without brightening the brighter parts too much.
The "dark part" in the dialog box is used to set the brightness. The larger the value, the brighter it is. Commonly used parameters range from 0 to 50.
Other options commonly used parameter range is 30~256.
6. Sharpen clearly: the menu bar "Filter-Sharpen clearly ..." opens the dialog box. It is used to make a blurred image clear. However, if the image is too blurred, it cannot be made clear.
Quantity is used to set the sharpening degree. The larger the value, the more obvious the sharpening and the more obvious the boundary.
The radius parameter is mainly aimed at the width of the boundary. As shown above, the transition distance between the avatar and the background is relatively short, so the radius can be set smaller.