Current location - Plastic Surgery and Aesthetics Network - Wedding planning company - How to press the elevator button
How to press the elevator button
1, the elevator up and down position is not reversed;

2. Press the up key when going up, and press the down key when going down.

For example, on the first floor, if you want to go to the tenth floor, please press the up arrow or press the button on it. If you want to go to the underground parking lot on the first floor, press the down button or the down button.

And > | |< means to close the door. & lt| | >; It means open the door. The red button of the bell is usually an alarm clock. Don't press it unless there is danger.

Extended data:

Commonly used are: handle switch orientation, axis layered switch orientation, logic circuit orientation composed of permanent magnet switch and relay in axis orientation, mechanical layered selector orientation, bistable magnetic switch and electronic digital circuit orientation, and electronic pulse layered selector orientation.

Elevator orientation, floor route selection: elevator orientation control is to compare the elevator with the floor position signal according to the passenger's destination floor instruction and floor call signal in the elevator car. All elevator instructions and floor call signals on the elevator position signal will make the elevator go up, and vice versa. Direction control link must pay attention to the following points:

The elevator should run in the direction of the call signal from the farthest floor. When the driver is operating, when the elevator has not started running, the driver should be given the possibility of forcibly changing the running direction of the elevator. In the maintenance state, only when the maintenance personnel directly and continuously press the direction button in the car or on the control box at the top of the car can the direction control of the elevator run, but when the direction button is released, the elevator will stop.

Floor display circuit: there must be a floor display in the passenger elevator car, and the floor display on the landing is determined by the elevator manufacturer according to the situation;

There used to be monitors on every floor of the elevator. With the improvement of elevator speed and group control dispatching system, many elevators cancel the floor display of landing or only keep the floor display of base station. When the elevator arrived at the call station, the acousto-optic forecast board was used. If the elevator is about to arrive at the station, the station bell rings, the direction light flashes or indicates the running direction of the elevator, and some people announce the station by voice in the carriage to remind passengers.

References:

Baidu encyclopedia-elevator

References:

Baidu Encyclopedia-Elevator Control System