Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and beauty - The van is short. I want to add a chain to the tailgate. How to add it appropriately?
The van is short. I want to add a chain to the tailgate. How to add it appropriately?
Park the car on a level ground, disconnect all vehicle electrical appliances, and remove the taillights, license plates and spare wheel frame to make enough space for installing the tailgate. Place the bracket on the ground and install the panel. The locking screw of each pin ear should be fixed reliably to prevent loosening.

The measured main girder spacing is equal to the relevant installation dimensions. Check the tail end surface to make sure there are no protrusions. Position the bracket, install the positioning splint, and then weld the bracket. Fix the power station and the electric cabinet, and fix the power station and the electric cabinet on the side of the truck with a fixing bracket.

Oil pipe and wire connection

Anti-collision rubber pads and safety chains are installed. The anti-collision rubber pads are installed on the vertical beams on both sides of the carriage, and the height of the tailgate is around the middle and upper parts when it is closed. If the width of the tailgate panel is less than the width of the carriage, ear contact rubber pads should be added on both sides; If it is a tailgate car or a flatbed car, it is necessary to set a channel steel at the end of the bottom plate as the stress point when the tailgate is closed. Safety chains are installed at the corresponding positions of the locks on both sides of the rear door and panel of the automobile.

Install license plate and test rated load of tailgate. There are many domestic manufacturers who install truck tailboards, such as good quality, reasonable price, brand awareness and after-sales service. These are the indicators that we need to consider when installing tailboards.