Dumper truck PTO installation video tutorial

1. The installation method of automobile power take-off is as follows: 1.

2. Remove the original car from the gearbox, remove the clutch housing from the gearbox, and keep the removed screws and studs for later use.

3. Remove the bearing cap from the transmission.

4. Remove the first bearing lock nut (left-hand thread).

5. Tap the shaft lightly to loosen one bearing and remove the next bearing.

6. First remove the gear spacer from one shaft, and then remove the stop ring from the gear of the next shaft.

7. Pull out the shaft to separate it from the shaft gear; 2. Install the short shaft connected to the power take-off into the gear box, and install the short shaft (accessory to the power take-off) into the first The internal splines of the shaft gear completely expose the open ring groove inside the first shaft gear.

8. Install the removed stop ring into the shaft gear hole.

9. Place the removed gear spacer on the short shaft, close to the stop ring.

10. Install the bearing. Install the stop ring on the bearing (power take-off accessory) and install it together on the stub shaft.

11. Install the stop washer and round nut (power take-off accessory) on the short shaft to ensure that the round nut is tightened reliably; 3. Install the mezzanine power take-off on the gearbox and clean the gearbox Debris on the box joint surface.

12. Apply sealant evenly to the joint surface of the gear box.

13. Install the paper pad in the power take-off attachment on the surface of the gearbox coupling.

14. Remove the six M18*2.5 screws on the power take-off and the connecting plate.

15. Install the connecting plate to the gearbox with six M16*40 screws and four M12*40 screws and spring pads connected to the power take-off.

16. Install the paper pad removed from the power take-off on the connection plate, and use 6 M18*2.5 screws and spring pads removed from the power take-off to connect the power take-off and the connection plate Connect them; 4. Install the clutch housing. After removing the studs, screws, nuts and washers from the clutch housing, install the clutch housing on the power take-off (note: the screws should be tightened reliably).

One million car purchase subsidies

The address of the plastic surgeon's full set of txt.

Plastic surgery did not achieve the expected results.

Hardware facilities of Taicang Renai Hospital

Which is better, Tongji Oral Cavity in Yanchang Road or Oral Cavity in the Tenth People's Hospital?

Characteristics and effects of Hami potato

What is the telephone number of Fanghuali Sales and Marketing Center in Nanning Jiahe City?

Does Chongqing andrology disease have those symptoms?

Bus from Sanguang, Lian Fang Road to Zhonghua Street

Does it hurt to hit the ear bone? Where is it less dangerous to play? When is the best time to play? What kind of care do you need after playing?

Look for answers to the 2010 Western Medicine Comprehensive Postgraduate Entrance Examination Questions for high scores. Both the URL and the answers are acceptable.