The operation process of a servo press usually includes the following steps:

1. Preparation: Confirm whether the equipment and safety devices of the servo press are working properly, and check the press Check whether the hydraulic system has enough hydraulic oil and ensure the safety of the work area.

2. Adjust working parameters: Adjust the working parameters of the servo press as needed, such as pressure, speed, stroke, etc.

3. Clamp the workpiece: Install the workpiece to be processed on the workbench of the servo press, and fix and adjust it as needed.

4. Start the press: Press the start button to start the power supply of the servo press, and make sure that the indicator lights display normally.

5. Perform processing operations: According to the processing requirements, control the servo press through the control panel or joystick to perform processing operations. Different processing effects can be achieved by adjusting parameters such as pressure, speed and stroke.

6. Monitor the processing process: During the processing process, promptly observe the processing status of the workpiece and the working status of the press to ensure the safety and stability of the processing process.

7. Complete processing: When the workpiece is processed, stop the servo press and remove the processed workpiece.

8. Cleaning and maintenance: Turn off the power of the servo press, clean the work area, and perform routine maintenance on the press to ensure its normal operation.

It should be noted that the specific operating procedures of the servo press may vary depending on different press models and processing requirements. The operator should be familiar with the equipment and relevant safety regulations. operate.