Return to the factory for repair. This is a phenomenon that sheet metal repair is not done well. Judging from this small rear-end collision, this gap will not cause much damage to the car, but the aesthetics are much worse. This gap is relatively easy to adjust. It is enough to adjust the screws of the fender at ordinary times.

Standard:

Left-right symmetry margin of gap roughness of car body detection parts

(1) Hood-Front Bumper 4.5 4.52mm1.52mm 3mm.

(2) Hood-headlight 3.5 2.5mm 01.5mm 3mm.

(3) Hood-front fender 3.51.5mm-11.5mm 2mm.

(4) Front fender-headlight11mm01mm01mm

(5) Headlight-Front bumper 2.5mm 2.5mm 3mm

Generally speaking, less than 10MM is acceptable.