The principle of touch induction lamp is that the electronic touch ic installed inside forms a control loop with the electrode plate under the touch of the lamp. When the human body touches the induction electrode plate, the touch signal generates a pulse signal through pulsating direct current, which is sent to the touch induction end, and then the touch induction end will send out a trigger pulse signal to control turning on the light; If you touch it again, the touch signal will generate a pulse signal through pulsating DC and send it to the touch sensing end. At this time, the touch sensor will stop sending out the trigger pulse signal, and when the alternating current crosses zero, the lamp will naturally go out. But sometimes it will light itself after power failure or voltage instability. If you touch paper or cloth and have excellent sensitivity to the received signal, you can control it.
First, the corridor is equipped with LED human body induction lamp.
The traditional induction lamp has many installations in the corridor, which generally consists of two parts, one is the switch of the human body induction panel, and the other is the light source, most of which are incandescent lamps. The two are separated, so the lines and positions should be laid out when building. The tungsten filament in incandescent lamp can't stand frequent switching, and the broken lamp needs to be replaced every year, so the manual maintenance cost is too high. LED human body induction lamp has built-in light source and human body induction device, so you can reach human body induction lamp only by installing and screwing in the general E27 lamp holder. The light comes on when people come, and goes out when people leave. When it is installed, it is placed at the corner of the stairwell, and people who go up and down the stairs can feel it. In addition, the LED light source has long service life and low working voltage, and frequent switching has no influence on it.
Second, the balcony is equipped with LED human body induction lamp.
For a long time, most of the lighting on the balcony is incandescent lamp or ceiling lamp. The balcony belongs to semi-outdoor. Turn on the light at night, mosquitoes and flying insects will turn around the light, and I don't remember to turn off the balcony light from time to time in my life. Install LED human body induction bulb or human body induction LED ceiling lamp at this position, both of which can be solved. LED is a cold light source, which does not contain ultraviolet rays and will not attract mosquitoes. It can intelligently perceive the human body. The light is always on when people are on the balcony, and it goes out when people leave, which saves electricity and is convenient.
Third, the property corridor is equipped with LED human body induction lamp.
There are dozens of families in a building, and it is also very suitable to install LED human body induction lamp in the public corridor of each floor. Every time the owner comes home and walks out of the elevator, the LED induction lamp lights up. In the delay time of 1 minute, the owner has enough time to open the door and enter the house by himself, which is much more energy-saving than the light bulb that has been on at this position. But to install this light in this position, real estate developers or property can make a decision.
Fourth, the utility room is equipped with LED human body induction lamp.
The utility room is a messy place. The room is small and dark. I can't see where the switch is when I go in. Put down your things and turn off the lights when you come out. If it's so troublesome, installing an LED human body induction lamp will solve it. Install it at the top of the room. When you open the door, the light will turn on automatically. The light will be on all the time when you rummage through the things. Take what you are looking for and go straight. There's no need to be careful. No one turned off the light for 60 seconds.
Five, the bathroom is equipped with LED induction lamp.
Isn't the bathroom equipped with LED induction lamp afraid of humidity? Don't worry, the plastic shell of the lamp body and LED beads are not afraid of moisture as light sources. The lights are always on when people are in the bathroom. When people go far away, they don't have to press the switch, so they don't have to be afraid of the danger of getting an electric shock when their hands are wet.