What if the bottle cap is deformed? In our daily wear, we should not only wear beautiful clothes, but also wear a beautiful hat. Sometimes hats deform. Let's take a look at what I have collected about the deformation of bottle caps. Welcome to reading.

What should I do if the bottle cap is deformed 1 Method 1:

Make a paper ball with newspaper, fill the bottle cap, put it out for a day or two, and the bottle cap will swell with it.

Method 2:

When the hat is eight minutes dry, blow it out of the hat pocket with a hair dryer at low temperature, and the "plastic" hat will also be improved.

Method 3:

If all the above methods don't work, teach MM another cruel trick, that is, wet the bottle cap slightly, put a layer of wet cloth on it, and iron the deformed place through the wet cloth, and the effect is also leverage.

What if the bottle cap is deformed? 2 1. Prepare a deformed bottle cap.

2. Prepare manual inflatable hat forming machine and hat forming spray.

3. Press the inflation device of the extrusion molding machine shown in the figure below to make the molding machine full of gas and expand.

It can be seen that the shaper gradually becomes full and stops when it is 80% full.

5. Then put the hat on the shaper above.

6. Continue to squeeze with the inflator until the shape of the hat returns to the figure below.

7. Finally, shape the hat with styling spray.

What if the bottle cap is deformed? 3 knead it into a ball with newspaper. Then adjust the adjusting button of the hat to the size of the hat you usually wear, and then put the spherical newspaper in the hat. Leave it for more than 24 hours. Use a plastic bottle that can hold boiling water. Turn the hat upside down, preferably hanging. Put the plastic bottle in and let it stand 10 minute.

Soak the wool cap in warm water, let it stand for ten minutes, take it out and open it to dry. If it is not ideal, use a hair dryer to blow as you like, and be careful not to burn it. Soak in warm water for a period of time, and it will feel soft by hand, then clean it and find a balloon to blow it to the size of the inner ring of the beret, that is, the balloon can just hold up the beret hat without falling off, and then take it to the shade to dry, and the hat will return to its original state.