1. Prepare tools
In order to replace the buckle of Tucson A-pillar interior trim panel, tools need to be prepared, including screwdriver, hammer, jumping wood, pliers and so on. , and the materials needed to replace the buckle, such as steel wire, metal support piece, etc.
2. Remove the old buckle
Remove the old buckle on the new Tucson A-pillar interior trim panel, unscrew the screw with a screwdriver, then remove the support with a hammer, and then remove the old buckle with pliers.
3. Install a new clip
Install the new buckle to the new Tucson A-pillar interior trim panel. First, install the new buckle on the panel with jumping wood, then fix the new buckle with pliers, then fix the new buckle with screws, and finally fix the new buckle with supports.
4. Adjust the position of the plate
After installing the new buckle, it is necessary to adjust the position of the new Tucson A-pillar interior trim panel to meet the needs of different space sizes. Adjust the plate to the corresponding position with pliers, and fix the plate to prevent the plate from loosening.
5. Check the installation
After installing the new buckle, it is necessary to check the installation result, whether it is installed firmly and whether the space size of the new Tucson A-pillar interior trim panel meets the requirements. If there is any problem, you need to readjust the installation until it meets the requirements.
The above is a series of operations to replace the buckle of the new Tucson A-pillar interior trim panel. Replacing the buckle of the new Tucson A-pillar interior panel can not only change the size of the space, but also change the structure of the space and improve the utilization rate of the space. However, if you want to achieve good results, don't rush to operate. You should follow the correct steps, take your time and check carefully to ensure the quality of the buckle change.