A, mechanical installation must pay attention to the fuselage to safety grounding, power supply is not allowed to be directly connected to the button, to install iron shell switch to control the power supply. Second, check whether the parts are complete before use, and whether the selected moving gear is in line with the speed of the steel bar diameter bending machine. Whether the meshing clearance of cone is appropriate. Whether the fixed iron wedge is fastened firmly. And check whether the rotating direction of the turntable is consistent with the direction of the reverse switch. And add grease as required. Check whether the insulated grounding wire of electrical equipment is damaged or loose. And after the trial operation, qualified rear can run. Three, operation, one end of the steel bar to be bent should be fixed in the gap between the turntable and the shovel head, and the other end should be fixed against the fuselage and pressed with one hand. It must be noted that the shovel head of the fuselage is indeed installed on one side of the steel bar before starting. Four, replace the fixed shovel head on the turntable, should be replaced after the operation stops. Five, it is forbidden to bend the mechanical brand steel bars and lifting rigging hooks that exceed the specified diameter. Protective glasses must be worn if bending unredrawn or rusted steel bars. When bending non-ordinary steel bars such as low alloy steel, the maximum limit diameter should be converted according to the provisions of mechanical famous brands. 6. The installation of the speed-change gear shall be as follows: the speed-change gear can be installed on ordinary steel bars with diameters below 1 and18 mm.. 2. When the diameter is 18 ~ 24 mm, the medium speed gear can be used. 3. When the diameter is greater than 25mm, slow gears must be used. Seven, turntable reverse, must stop after the previous turn. When toggling the switch, you must wait for parking in the middle parking gear, and do not reverse the direction gear immediately. If it is found that the chuck vibrates and the motor heats up beyond the requirements of the famous brand during operation, the power supply should be cut off immediately for maintenance. Eight, bending steel rotation radius, the fuselage without a fixed shovel head are not allowed to stand. Bending semi-finished products should be packed neatly, and the hook should not be upturned. Nine, when bending the long steel bar, there should be someone to help the steel bar, and the person who helps the steel bar should advance and retreat according to the operator's command gesture, and should not push and shove at will. Ten, after the work, the workplace and the fuselage should be cleaned up, and the rust in the joint pit will be blown off with a manual blower (leather tiger). Do not dig with your fingers.

For more information about project/service/procurement bidding, and to improve the winning rate, please click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd