1, according to the provisions of the machine lubrication diagram, according to the requirements of oil cup lubrication and manual lubrication.

2. Roll the plate according to the parameters specified by the hydraulic plate rolling machine. The thickness of the plate is 20mm, the longest is 2500mm, and the yield limit of the rolled plate material is less than 250Mpa.

3. After turning on the power supply, move the lower roller up and down and the upper roller up and down, and check whether there is any abnormal jamming in each movement.

4. Pay great attention to the safe operation of the equipment when the upper roller rises and falls to the limit position in strict accordance with the processing procedure and operation method of the hydraulic plate bending machine.

5. When the main drive stops, the upper roller can be lifted, and the tilting reset of the tilting bearing and the tilting of the upper roller can be carried out.

6, in the process of operation, if found to have irregular noise, impact and other abnormal phenomena, should immediately stop for inspection.

7, in the operation of the personnel should coordinate with each other, listen to the command of the head of the plate rolling, no password, it is forbidden to start the machine.

8. Pay great attention to the hand being pressed by the steel plate when the hydraulic plate bender rolls the plate, and roll it in with the steel plate.

9. Be careful not to collide with the machine when lifting the steel plate or steel drum with the crane.

After the completion of the hydraulic plate bending machine, the site should be cleaned after work, the equipment should be well maintained, and the power supply should be turned off in time.

The upper roller plate bender is driven by the lower roller and electrically controlled by the operating system. It can complete the pre-bending at both ends of the plate and the winding of cylindrical and arc-shaped workpieces at one time, and can also reshape and level the metal plate to a certain extent, which has the effects of direct pre-bending, saving trouble and material, and is controlled by the numerical control system to improve the degree of automation. This machine is widely used in industries with high precision requirements, such as aviation, nuclear power and other metal structural parts manufacturing, chemical machinery, offshore oil platforms, oil and gas pipelines and so on.