Saw is used to cut parts.
3 model cutting, carving and even marking, one of the most commonly used tools.
Nozzle pliers are used to cut parts from the board, which can prevent leaving too deep marks on the model.
5 is used to carve lines to increase details and complexity.
6 Clamping small parts for use
Same as above, but different shapes are suitable for different occasions, which one is convenient.
8 emery file is used for preliminary grinding and shaping, and the effect is rough, but it is polished quickly.
9 Bonding ABS material, the principle is to melt the material slightly, then fuse the two melted materials, and it will be solid after drying.
10 is used to separate parts from the model.
1 1 is a tool for drawing lines on the model, which increases the sense of hierarchy.
12- 15 The tool for surface polishing is more detailed than the file.
16 for storing tools.
17 Everything from rough grinding to fine grinding. Sandpaper should be used at the end of grinding operation.
The simple bending of metal plate is generally an etching tool table (such as a right angle), but it is very difficult to bend a three-dimensional surface, which is generally not made by hand.