100T is very simple. First, put the two cones in place, cutting, gas cutting or numerical control plasma cutting. Then roll the lower cone with a rolling machine. Generally, the lower cone is spliced in two sections according to the material requirements. The upper cone can be directly welded by crane. When designing the tank body, it can be designed according to the circumference, so that the18m or 9m long plate can be directly opened with small tools, pulled back and hung up, pushed by workers at both sides, and a steel plate ring can be ignited with a welder. Then the edge of the steel plate ring is surrounded by a channel steel ring, and a cone, an upper cone and a lower cone are added, so that the whole cement silo is spliced into two sections. Then weld the legs on the cone. Then make the lower shelf according to the discharging height, and finally connect the lower shelf and the jar with bolts on site. The whole process is roughly like this. You can talk about it in detail if you don't know. I hope I can help you.