Vacuum compression storage bags and vacuum packaging can reduce the volume.
Vacuum compression bag is a kind of bag mainly used to hold quilts and various clothes. Its working principle is to extract the air from the quilt clothes to reduce the volume. Install the slider, press the zipper of the slider by hand, and slowly and gently pull it to the other end of the zipper. When it is pulled to two thirds, squeeze or fold the clothes or quilt to let most of the air out, and then quickly pull the remaining one third with the slider. It can save a lot of time and effort to pump air with a manual pump.
Application mode
1. Open the bag, arrange the quilt or clothes and put them in, at least a few centimeters away from the sealed zipper.
2. Pull the bag mouth by two thirds, leaving one third, and open it at 1/3.
3. Roll up the quilt or clothes so that most of the air can be discharged from the mouth at the speed of13 (this will save a lot of effort in pumping air! Generally speaking, it takes about 2 minutes to draw a package!
4. Quickly pull up the remaining 1/3 openings and seal the zipper part. If fibers and dust enter, the sealing performance will be reduced. Wipe or blow clean with gauze soaked in water before zipping.
5. Slide the zipper back and forth at the seal to ensure that the bag is really closed.
6. You can use a vacuum cleaner or air pump to suck air, aim the mouth of the vacuum cleaner or air pump at the valve and start sucking air. After the air in the bag is exhausted, quickly pull out the suction nozzle, cover the valve cover and press the valve cover hard. People who use pump should pay attention, because it takes a long time to pump big bags. You don't have to smoke it all at once. You can stop in the middle, tighten the suction door, and the air can't enter. After the break, or if you have time, continue to smoke. Be sure to cover the valve cover after pumping!
2. How to pack the quilt express?
The best way is to put the quilt into a vacuum storage bag for express delivery. Details are as follows:
1. Open the lid of the vacuum storage bag:
2. Fold the quilt, fold it into a square sample as usual, and then put it into the storage bag:
After the quilt is put in, remember that the quilt should be flat, otherwise it will not look good after compression. After everything is done, be sure to seal it with tablets, otherwise it will leak.
4. After sealing, you can press it by hand to see if there is any leakage in the bag, otherwise it will lose the meaning of vacuum packaging. At this time, you can use a manual vacuum pump with a circle of threads on it, which can be screwed on to evacuate the air inside.
5. The compressed package after evacuation is not only beautiful, but also saves a lot of places. At this time, you can add a woven bag or other packaging supplies outside for express delivery.