When wrapping column corners with aluminum plates, the aluminum fillets should be fixed first, then the aluminum plates should be decorated, and then closed with battens. The closing panels should be made of aluminum plates or aluminum-plastic plates, and their varieties and specifications should meet the design requirements. Frame material a, glass magnesium board uses 12mm thick glass magnesium board.
Wall panel joints are usually prone to uneven top and bottom or unequal board surfaces at the joints of the joints. Therefore, one side of the board should be installed first, and the alignment should be positioned using horizontal and vertical control lines. For the installation position of the other side panel, after both sides of the panel meet the requirements, pull out the rivets in turn and install the pressure plate to fix it.
The lower end of the wall is closed, and a special water retaining plate is made according to the actual size to seal the lower end. At the same time, the gap between the plate and the wall is covered to prevent rainwater from penetrating into the room. When installing, pay attention to the gap between the plates. Gaps and height requirements for panel interfaces 12. After the aluminum plate is installed, cover and protect the parts that are easily contaminated with plastic film or other materials.
The column-wrapped aluminum veneer is installed horizontally. Only horizontal installation can ensure the uniformity of the square column formwork and prevent the column-wrapped aluminum veneer from bulging.
The installation spacing is reasonable. The installation spacing of the column-clad reinforcements must be consistent with the square column size specifications, otherwise it may cause mold explosion. The larger the size of the square column, the smaller the installation spacing of the reinforcements. .