1. First, insert the hot melt adhesive stick from the back of the glue gun, and pull the trigger several times to let the glue stick enter completely. Insert the glue gun into the power socket, preheat it for 3 to 5 minutes, let the hot melt adhesive melt completely, select the appropriate traction gasket according to the diameter of the dent, pull the trigger of the glue gun, and apply the melted glue on the traction gasket. Align the traction pad coated with hot melt adhesive with the center of the depression, and gently press it by hand. 3. After 5 minutes, align the center hole of the tension bridge with the shaft of the traction gasket and install it;
2. Pull out the gasket evenly to make it sink slowly;
3. Because the position is eccentric, the tool hook can't be inserted from one side, so we have to dismantle the door. Only when you find the right tools can you tear down the door.
4. First remove several fixing screws hidden in the interior trim panel, and then knock the interior trim panel open with even force. Our shark skin dent repairer has an average repair experience of not less than three years, so the interior trim board was removed three times, five times and two times. Be careful not to break the belt buckle when you make it yourself.
5. The next step is to remove the wire harness. Be careful to remember the original positions of the wiring harness and the corresponding interfaces. Don't open it for the time being, it will be forcibly opened during installation.
6. The interior has been basically disassembled, and the hook is easy to sag, which is generally enough. Find a special iron fixing bracket and fix the door to ensure that it will not move back and forth during maintenance. Then, extend the hook to the opposite side of the depression, press the eyes evenly, and stare at the change of the surface of the depression in real time with the help of the light emitted by the lamp board.
Million car purchase subsidy