2. Calculate the revolutions of each part of the motor. Before embedding the conductor, the assembly hand should count several turns, and then embed it evenly. Non-linear turns should be straightened (root and root winding unit) to make them cross.
3. When burying for the first time, try to make the conductor grooves cross, and a small amount of cross should be carried to the end position by hand.
4. Place the initial winding die slightly. As for the sharp bend on both sides of the coil slot, let's do it on the single-layer winding. I'm so sure.
5. For each embedded coil, it is necessary to shape the coil, pad it with a suitable wooden stick, and knock it to the outer circumference, so you can basically see through it.
6. Pull in the first component side, and pull in the second component side should be correct.