What should I do if the operation of narrowing the alar fails?
If the rhinoplasty operation fails, you can go to the hospital for repair surgery 2-3 months after operation. During the repair operation, it is necessary to pay attention to the selection of some more professional and regular hospitals and do a good job of postoperative care. After the failure of alar reduction, it can basically be saved. It is suggested that beauty seekers go to regular plastic surgery institutions for surgery under the close consultation of professional and experienced plastic surgeons to avoid the failure of surgery again.
How to repair the failure of alar reduction operation
1 If the alar is too small and uncoordinated, surgery can be performed to fill the alar with prosthesis or cartilage tissue to make the whole alar coordinated.
If the alar is still thick, you can do another operation to remove part of the thick alar tissue and improve the imperfect alar.
How is the alar reduction operation done?
Nasal alar reduction is to make an incision at the base of alar or the lower part of alar groove. Of course, anesthesia must be carried out during the operation, and then part of the alar basal tissue should be appropriately removed according to the actual situation of the beauty lover, and then the nostril should be narrowed by internal rotation. Finally, the surgical site should be sutured intermittently in layers. The effect of the operation is very good. The length of scars left after operation is generally less than 1CM, and these scars are hidden and often difficult to find. Due to the alar reduction operation, part of alar tissue was removed from vertical and horizontal directions, the length of alar was corrected, and the nostril circumference was reduced. After operation, the alar hypertrophy was significantly improved compared with that before operation, and the appearance of the whole nose was more harmonious.
Common methods of alar reduction surgery
1. If the alar is too wide or too thick, we can make an incision along the front edge of the lateral foot of alar cartilage, and then use small scissors to separate the skin from the alar cartilage below. Pull the alar cartilage out of the incision with a small hook, cut off the soft tissue on the cartilage surface, and then cut off the upper and lower parts of the cartilage.
2. For patients with nasal hypertrophy, a V-shaped skin incision can be made along the front edge of the lateral foot and the medial foot of the alar cartilage, and the nasal cartilage can be separated sharply through the incision. Pull the alar cartilage out of the incision as far as possible with a small retractor to cut off the adipose tissue on the cartilage surface. Then, most of the upper and lateral parts of the cartilage are removed, leaving only an L-shaped cartilage at the center and edge.