Huawei router commands are similar to Cisco. Using it well can greatly facilitate our daily work. I provide you with the following Huawei router commands, hoping to help your work!
Huawei router command 1
1. Delete device configuration: reset the saved configuration.
2. Reboot: Reboot
3. View current configuration file: display the current configuration.
4. Change the device name: sysname
5. Save the configuration: Save.
6. enter privileged mode: sysview
Note: Huawei has only two-tier mode, unlike Cisco enale, which needs conf t.
7. Define acl:
After xxxx (above 3000) enters ACL, the rules allow/deny IP/TCP/UDP and other sources.
Xxx.xxx.xxx.xxx.xxx.xxx.xxx (reverse) destination xxx.xxx.xxx.xxx.xxx.xxx.
XXX。 XXX.XXX.XXX (anti) eq Note: Huawei has not denied any breach of contract.
8. Port loading ACL on firewall ACL: [quidway-Ethernet 0/0]/0] Firewall packet filtering 3000 inbound.
9. Newly added users on the firewall: local user XXX (user name) password is simple XXX (password) local user XXX.
Service ppp
10. Delete command: Undo (similar to cisco no)
Huawei Router Command 2
1. On the primary vrrp device, you should specify:
Stp Instance 0 Root Primary stp TC- Protection Enabled STP Enabled
2. On the slave vrrp device, specify:
Stp Instance 0 Root Secondary stp TC- Protection Enabled STP Enabled
3. Binding acl under the switch:
First, enter the interface mode and enter the qos command: [SHZB-CRSW-S6506- 1 Gigabit Ethernet11] QoS.
Enter the following command: [shzb-crsw-s6506-1-Qoss-Gigabit Ethernet11] packet filtering inbound.
Ip group 3000
Note: Huawei switches can only specify the inbound direction.
4. Enable ospf:
[shz b-crsw-s 6506- 1]OSPF 100
Region 0
[shzb-crsw-s6506-1-OSPF-100-area-0.0.0] network XXX. XXX.XXX.XXX
XXX。 XXX.XXX.XXX
5. Configure ospf republishing:
[shzb-crsw-s6506-1-OSPF-100-area-0.0.0] exit.
[shzb-crsw-s6506-1-OSPF-100] Import-Routing Static
Establish a link group (similar to Cisco's channel group): link aggregation group 1 mode.
Manually, and then enter the interface: port link aggregation group 1.
Note: Before enabling VRRP, you must enter: vrrp ping-enable so that customers can ping the gateway.
;