1. The tools used to make ornaments are as follows:

(1) Side shears: mainly used for cutting copper wires. Generally, string beads are used, and ordinary scissors will do.

(2) Needle-nosed pliers: in beading, it is mainly used to tighten the fishing line. Because some beads are so small that it is difficult for needles to pass through occasionally, fishing lines should be used.

(3) Round-nosed pliers: mainly used for making copper wire rings, but rarely used for beading fishing lines.

(4) The cushion below is dedicated to beading, and the material of the sponge will not be too slippery when taking beads.

2. Other tools:

(1) Triangle plate: This plate is used for counting beads or taking them back from the mat, so it is very convenient to run around without beads.

(2) Beaded needle: Mabai beaded needle has three models,10/112. The larger the number, the thinner the needle and the smaller the pinhole. Here I suggest using the 1 1 needle. The needle 12 is too thin, and it is too difficult to find the thread. Anyway, I didn't find anything to pass, so I was idle.

(3) Beaded fishing line: In fact, there is another kind of jewelry line, but if not, I generally don't introduce it, because there are many forks at the end, which is really strong. It is very troublesome to finish Martin. I recommend 0. 12mm for this fishing line, which is very strong. For 1.5mm beads, it is no problem to wear them back and forth three times in the production. The thicker fishing line is 0. 14 mm, and the string 1 1 needle needs skill, which is used for 65438+.