Handstrings can be made of thin red rope, such as long knot, unity, oblique knot, double money knot and so on. And the anklet can be relatively simple, flat knot and double connection.

The knitting method of diamond red rope bracelet is not complicated. Just prepare two red ropes and follow the knitting diagram of the red rope bracelet below step by step.

Weaving method steps of red rope bracelet with diamond knot 1, select red rope and corresponding pendant, red rope can be used only when no pendant is needed, and each bracelet uses about 160cm;

The second step is to fold the red rope in half, start weaving patterns, tighten them evenly, and leave a small hole as a buckle;

Weaving method of red rope bracelet with diamond knot Step 3, the second diamond knot starts from the previous one, as shown in the figure, and the second knot is tightened, and the second thread is crossed to prepare to weave the third diamond knot;

Step 4: Weave a red rope bracelet with a diamond knot. Tension complete. When the length of the bracelet is average, put on accessories and continue to knit the diamond knot of the other half.

Step 5: Placement method of red rope: The red rope below is wound upward through the double ring, and then enters the middle square hole, and the other rope tail is wound backward into the same square hole, and then the three-dimensional structure is gently pulled up, adjusted and tightened. Subtract the excess red rope, and the tail is glued.