Take out a 0.7mm elastic thread.

Penetrating locating bead

Keep a 2mm clamp level.

Pass through the buckle from the other end of the line.

Pay attention to the inward opening.

The buckle covers the locating bead.

Clamp the buckle with needle-nose pliers.

Clip into a convex flat shape

You can start beading.

Just put them in order.

When finished, insert the buckle first, and then insert the positioning bead.

Clamp the locating bead flat with needle-nosed pliers.

Leave 2mm elastic thread and cut off the rest.

Close the buckle and clip it flat.

Take out a 5 mm split ring.

Fasten the bag button and lobster button

Then close the split ring with a ring.

A second split ring is used at the other end of the bracelet.

Fasten buckle and extension chain.

Take out a T-nail.

Insert beads and transparent beads as shown in the figure.

According to the position on the drawing, clamp the T-pin with double circular pliers.

Bending t-pin

Clamp the t-pin

The backhand bends out in a small circle.

Fix the pendant on the elbow with a split ring.

Take out a 3 mm split ring.

Fix one end of the thin chain on the bracelet with a 3 mm split ring.

As shown in the figure, both paragraphs are buckled.

Then use the third 3 mm split ring to select the middle position of the thin chain.

Fasten the small circle bent by the T-pin.

The effect produced here is like this.

Finally, connect the small pendant with the fourth and fifth split rings, and it is finished.