1. Prepare some tools first, such as lighters, scissors, jewelry thread, ordinary jade thread, etc. Jewel thread is used because
Because the holes of some small pendants are generally small, jewelry lines can pass through the holes of small pendants; The ordinary jade thread is a bead.
The treasure line is thicker.
2. Thread the jewelry line through the pendant to form a circle.
3. Take the place where the jewelry line crosses as the main line, and start to tie a flat knot with the jade line, and tie it up and down from left to right.
Pay attention to estimate the length of the pendant rope, such as the figure of the person wearing the pendant, and then adjust the length of the pendant rope.
Usually, it is better to have a suitable size and length, not too short or too long, otherwise it will lose the aesthetic feeling of wearing and make the wearing effect useless.
That's great.
4. After the flat knot is completed, cut off both ends of the jade thread, and then light the thread end with a lighter, which becomes the following sample.
Son.
5. Pull the two ends of the jewelry line to both sides, to the end, cut off the excess line and light it with a lighter. In fact, the combustion has been completed.
After that, the rope end will not be too abrupt, which can block the roughness of this part.
Method 2
1, 4 pieces of 0.8 flat wax 120cm, 20cm at one end, and then weave a 60cm-long four-strand braid according to the size of your head circumference.
Set the length, remember to put the pendant in, face up.
2. Four strands of pigtails, leave one strand as long as 1cm and then fold it back, take another thread and make a short winding on it.
The end of the winding wire penetrates into the small hole.
3. Tighten the two wires at the same time, cut off the one that goes up and burn it, and do the same at the other end, and tie the two wires into one.
A diagonal knot, the other line on the left also makes a right diagonal knot on the axis, and then makes a left diagonal knot under the condition that the axis is wound unchanged.
The axis should be straightened.
4. Make a left oblique knot around the other line on the left, and make a right oblique knot around the two axes, on the right.
Do the same thing. The two windings are opposite, insert a 6mm agate bead, and leave windings on the left two shafts.
Oblique knot
5. Make a right oblique knot and a left oblique knot on the two winding lines, and do the same on the right side, with two axes inside.
An oblique knot, these two lines are tied with an oblique knot on the outer two axes, and the outer two axes are tied with an oblique knot.
Knot a knot.
6. Cut off all the extra threads and burn them, and then wrap a flat knot on the necklace rope.