Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and medical aesthetics - After the door was brushed, there was a small pit of rice grains. How to repair the rice pit on the car body?
After the door was brushed, there was a small pit of rice grains. How to repair the rice pit on the car body?
Many car owners will paint their own cars, but many car owners who have no painting experience find that there are rice pits on their cars after painting, and they want to know how to repair them. Actually, there are many reasons for this problem. The following are some common reasons for your reference.

How to repair the pit with rice grains on the car body?

There are depressions and pits on the car body, and it depends on the severity whether sheet metal is needed. If sheet metal repair is needed, the lining should be removed first, and then the small pit inside should be propped up with a suitable crowbar. Pit puller can consider repairing the position where double-layer or multi-layer board is not easy to operate. If the pit of the car body is too small to be treated with sheet metal, it is necessary to remove the primer nearby, scrape a layer of putty, and then repaint the putty.

There is a small pit of millet after the door is brushed.

There are three reasons why a pit the size of a small grain of rice appears after the door is brushed. The first is that there is no putty leveling before painting, which leads to uneven spraying position. When the paint dries, these uneven positions will become very obvious. The second reason is that when the paint is wet or water is added, even if a drop of water enters the paint, pits will appear on the painted leather surface, so don't inject water when shunting the paint. The third reason is that the paint was not wiped with degreasing agent before painting, and the paint could not adhere to the greasy paint surface, thus forming a small pit the size of rice grains.

How to avoid paint leakage when spraying varnish in winter?

First of all, when painting, check the viscosity of the paint. If the viscosity is too high, the spray is not flat enough; If the viscosity is too low, the adhesion is too poor. Secondly, the adjustment of spray gun is also very important, so it is necessary to pay attention to the collocation of spray valve and valve, which has a great influence on the quality of spray painting. Finally, choose a quiet room when painting, and never paint in windy conditions, otherwise the paint flow problem will be more serious. If paint is used, then the high boiling point solvent should not be too much.