Some car shock absorbers and shock absorber springs are connected together, and shock absorber spring removal tools are required for removal and installation. The editor below will briefly talk about the steps and precautions for removing the shock absorber spring. You can refer to it when disassembling.

Safe operation steps for spring disassembly and assembly

1. Check the status of special shock-absorbing tools before use.

a. Confirm that the fixed connection between the special tool and the bracket is normal.

B. Confirm that the spring clamp matches the vehicle model.

C. Confirm that the spring tightening nut is tightened.

2. Fix the shock absorber assembly on the special tool.

A. Pre-tighten the compression nut and confirm that the spring and clamp fit tightly.

b. Tighten the compression nut and always pay attention to the state of the spring.

3. Remove the shock absorber mounting nut:

a. Confirm that the spring and shock absorber rod are in a free state.

b. Confirm whether the spring and clamp are firm.

c. Use special tools for shock absorber nut removal to remove the nut.

4. Install the shock absorber:

a. Confirm the installation position of the shock absorber, thrust bearing and buffer block.

b. Use a special tool for shock absorber nut removal to install the nut, and confirm that the nut is tight.

c. Gradually loosen the clamp until the spring breaks away from the clamp, and promptly correct the installation positions of the shock absorber, thrust bearing and buffer block.

Precautions for spring disassembly and assembly:

A. During the entire operation, the operator is on both sides of the shock absorber, not at both ends of the shock absorber. To prevent the shock absorber spring from flying out. The disassembly of the shock absorber spring is completed in the assembly and repair room, and no other irrelevant personnel are allowed around.

b. Prepare all tools and pre-replacement spare parts before disassembly. After the shock absorber nut is removed, the operator must not leave the site until all components are installed.

The above is the editor’s introduction to the steps and precautions for disassembly and assembly of automobile shock absorber springs. I believe everyone is more or less familiar with the disassembly and assembly of shock absorber springs. I hope the editor’s introduction can help everyone. If you like it, please give the editor a like.