Use your imagination, you can make many animals with the waste on hand, and there are countless ~! The following examples are for your reference ~!

You can use all kinds of melon seeds to puzzle; Leftover jelly shells can be strung together to make wind chimes; Used disposable paper cups and beverage bottles can be cut into flower baskets and the like.

All kinds of bottles and cans can be made.

For example: 1, use a toilet paper tube as a body, and stick an animal's ears, eyes, nose and mouth on it, which is a lovely animal. Toilet paper tubes can also be used to make tree trunks.

2. Envelopes can be made into bag dolls. Draw or paste eyes, nose, mouth and ears, cut a hole (semicircle) on both sides of the envelope, let the child or teacher put his hand in, and make a puppet by sticking out his thumb and little finger from the hole on both sides.

There are many, many, you can use your imagination.

All kinds of bottles and cans can be made.

Use a yogurt bottle as a stretcher.

It's a pity to throw away the discarded cans. This article teaches you how to make beautiful metal paintings with cans, which are best-selling handicrafts.

First, raw materials and production tools: all kinds of cans, pens, rulers, carbon paper, rubber pads about 3 cm thick; Small, medium and large scissors and carving knives, colored pens, watercolor or oil painting pigments, latex, multifunctional glue, sandpaper, lining paper, lining cloth, picture frame, etc.

Second, the production method:

1, wipe the bottom map: first design a beautiful picture as the bottom map, and then wipe the bottom map on the front of the cans with carbon paper (the cans have been cut in the middle before, so there is no need to turn around the tail). Because the outside of the long side is hard, the picture should be printed in the middle of the can as much as possible.

2. Tracing: Put the developed cans on the rubber mat, and trace with a ballpoint pen according to the copied lines. The tracing force should be moderate, and it is best to identify the line marks on the metal.

3. Molding: Extrude the drawn base map and sculpt it. According to the requirements of the base map, put the metal sheet flat on the rubber pad, with the reverse side facing upward, and squeeze and draw with a pen and nib according to the line marks. For the part to be depressed, the front pattern of the metal sheet is extruded and scraped by the above method. The operation force should be moderate and even, and there should be no obvious extrusion and scratches on the metal surface. Excessive force will crack the metal surface. Too bright to achieve the three-dimensional effect of the picture. By repeatedly squeezing and dicing and trimming back and forth, the picture can have a three-dimensional effect.

4. Cleaning: After molding, clean the picture with detergent to remove stains and make the picture clean.

5. Trimming and coloring: use scissors to cut off the forming picture of the cans, and the part that can't be cut off can be carved out with a meat cutter, and the picture can be trimmed. According to the requirements of the manuscript, the cut graphics are spliced together with glue to form a complete picture. Next, color with pigments as needed. It's best to use the true color of cans.

6. framing: check and trim the picture in all directions to make it more perfect. Then glue the lining paper (lining cloth) to the bottom plate of the mirror frame, then glue the painting to the lining paper (lining cloth) and put it into the mirror frame.