The driver's master helped unload the goods, and when he got close, he chose to carry it himself.

I have to say, the back seat is quite big. Put it all down

Unpacking inspection, this packaging rod rod

Open all the boxes and check them. Good quality!

Perfect!

Start tire shredding

Put on the blade

dynamic balance

When installing new tire pressure, be sure to take a picture of the number on the tire pressure before pressing it. You must press it to that position correctly! There must be no mistakes before and after. Take the photos to the 4S shop to match. If you make a mistake, you will have to pick up the tires if you don't match in the 4S shop.

Install a new hub cover.

I got in the car and loaded it. The master installed it carefully, and there was no bump during the whole disassembly process.

side effect

side effect

Raise your head. One?

Next, I modified the penetrating strip and contacted my friend's headlight modification shop. The master studied the method and prepared to start.

Pass it on. Post this thing? This fucking car sucks. It's better than the original one!

First, remove the penetrating lamp sent by the 4S shop, then remove the lamp and install it on the original penetrating device. 4S factory installed it in a lossless way, without destroying the original vehicle production line.

Install the light bar on the original car to penetrate the effect.

The real car works well! I have to say that the master is very skilled! This is probably the first local [pride] to be so modified.