1, exam preparation: exam preparation mainly means that our students need to go around the car counterclockwise to check the condition of the car. The details required in different places may be different, so I won't explain them in detail here.

2. Preparation for getting on the bus: After getting on the bus, adjust the seat, fasten the seat belt, step on the clutch, check whether the gear position is in neutral, whether the handbrake is pulled up, then check the lights and light them up after confirmation.

3. Simulated lighting operation: The lighting test will randomly select some questions. As long as you make correct actions within 5s, you won't fail. You know, the on-board system is connected to the vehicle management office, and once you make mistakes, you will fail the test. Lighting operation will not be interpreted too much here. Section 3 exam lighting all topics.

4. Start: Turn on the left turn signal first. After 3 seconds, we stepped on the clutch and brake and shifted to 1. After turning around to observe the safety of the left and right rearview mirrors, release the handbrake and slowly lift the clutch to start smoothly.

5. Passing through the school and bus station: slow down and walk slowly. Generally, lightly step on the brakes, observe the left and right, and pass after confirming safety. The speed is required to be controlled below 30 yards.

6. Turn left at the intersection or turn right at the intersection: Take turning left as an example. Turn on the left turn signal after entering the solid line. After more than 3 seconds, move the direction, step on the car involved and slow down. Be sure to follow the instructions of the traffic lights, pay attention to the road traffic situation, and make a left turn after confirming safety.