Please click to enter a picture description.
Spray a small amount of window film installation liquid on the outer surface of the contour-cut window glass, cover the window film on it, expose the film outward, carefully slide and position it, and then start cutting the size of the window film around the frame. In the process of cutting operation, the car film is firmly adhered to the glass. Skilled installers can cut the frame directly by hand without damaging the frame. Installers usually cut, trim and install all the side windows first, and then install the rear window glass. Theoretically, easy before difficult is the best installation sequence.
Please click to enter a picture description.
After heat setting, any bending on the glass will be obvious after cutting the window film size. Almost all rear windows (and many side windows) have spherical curvature to prevent the window film from spreading on the glass. This phenomenon on the window film is called wrinkling. Portable hot gun can shrink and shape the window film accurately on the compound curved surface of most windows. Eliminate wrinkles on the surface. However, in the past, most rear windows needed to cut multiple pieces of glass to be installed on the spherical surface. The hot gun heat setting method is carried out before installation, which not only saves a lot of time to deal with wrinkles, but also makes the appearance of window film more comfortable and beautiful. Thermoforming is the most important single process to accelerate the installation process and produce the most professional installation effect.
Please click to enter a picture description.
Please click to enter a picture description.
After cleaning the protective film glass, the protective film of the window film is torn off. After the installation liquid is sprayed on the adhesive surface of the window film, the installation liquid is also sprayed on the inner surface of the glass. Over the years, various exquisite technologies have been developed to make the installation faster and minimize the risk of dust particles brought in during the paving process. Laying of window film-Only when the protective film is removed and the installation liquid is sprayed on the adhesive layer between glass and window film can the side window glass slide into place. Film pasting-Laying of rear window glass As mentioned, the film pasting installation of rear window glass is the biggest challenge for installers, so we will talk about "the whole pasting skills of front and rear solar films" later. After each window film is fixed in its final position, the installation liquid should be sprayed on the surface of the window film again immediately to lubricate the extruded surface. Use a special water squeezing tool to remove all bubbles and as much installation fluid as possible. After a few days, the residual moisture is slowly discharged through the window film, and the drying time of the window film varies with the climate, humidity, structure of the window film and the amount of residual moisture after extrusion.
Please click to enter a picture description.
Final effect
Please click to enter a picture description.
Please click to enter a picture description.
Please click to enter a picture description.
Please click to enter a picture description.