Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and medical aesthetics - What tools does automotive sheet metal need?
What tools does automotive sheet metal need?
Tools used by automotive sheet metal.

1, the whole flat hammer?

The main force of outer panel forming. The hammer head is round and square, and the hammer surface is flat and slightly curved, which is used to level the outer plate.

2. sharp-nosed hammer?

Also known as "crane-beak hammer" and "crane-beak hammer", the hammer head at one end is slender and crane-beak-shaped, which is used to finely repair the small protrusions on the outer plate.

3. shrink the hammer?

The hammer surface is serrated, which will leave tiny marks when hitting the iron plate, which can effectively control the metal extension in the leveling process.

4. rubber hammer?

Rubber hammers with different weights can be used to mold metal outer plates and structural parts.

5. wooden hammer?

The light wooden hammer can effectively restrain the metal extension when the outer plate is leveled.

Step 6 clamp iron

Used in conjunction with various sheet metal hammers to provide support for steel plates when knocking. Steel plates can also be formed from the back.

7. needle withdrawal?

You can make a "mark" on the metal plate. Before repairing the rib line, mark it with a marking needle, so that the repaired rib line will not "run off".

8. hit the board?

Used to repair the rib line, and the repaired rib line is straight.

9. Ruler?

A seemingly ordinary ruler can easily judge whether the surface of a steel plate is flat or not through a "crooked" and a "ratio" in the hands of a sheet metal master.

10, rough crowbar?

Based on the lever principle, the depression can be roughly shaped in the plate from the inside out.

1 1, thin crowbar?

Using optical principle and lever principle, the vehicle can be repaired by painting without damage, and the "small bump" no longer needs a complete set of sheet metal painting.

12, flexible gear?

By observing the file marks, it is convenient to check the raised parts on the sheet metal, which is convenient for the sheet metal master to carry out subsequent leveling and repair.

13, pneumatic belt sander?

Old paint layer used to polish corners.

14, angle grinder?

There are two kinds of electric and pneumatic, with the same function. With the use of black diamond grinding plate, it can quickly polish the old paint layer on the board without damaging the galvanized layer of the original car.

15, small paint rust remover?

Mainly used to remove rust on steel plates.

16, pneumatic glue gun?

It can be used for bonding and sealing after the accident car is repaired, and has the functions of anticorrosion and waterproof. Through the nozzles with different opening shapes, the appearance texture of the glue punched by the pneumatic glue gun can be roughly similar to that of the original sealant.