1, the first step: wash the car, clean the inside and outside of the car, drive the car to a clean and dust-free place and wait for the film;

2. Step 2: Measure the window size and cut the film according to the size. The size must be right. If you are not sure, the size can be slightly larger, but it must not be small;

Step 3: Clean the window glass. This step is very important, because if there is dirt on the glass, even a little bit will affect the quality of the film. Two scrapers, a hard scraper and a soft scraper, should be prepared in advance (usually sold in accessories stores). Spray water on the glass (detergent should be put in the water), first scrape off the obvious dirt on the glass with a hard scraper, and then scrape off the water mark on the glass with a soft scraper. Repeat this three or four times until the water is completely removed. Finally, spray water on the completely cleaned glass window and close the window, leaving only the person who pasted the film in the car;

4, the fourth step: film. Tear the film, spray water evenly on the effective film surface, and put the torn plastic film aside for use. Leave a distance of 5- 10mm above the glass, and stick the sprayed film surface on the car glass and fix it. If the film is slightly cut, cut off the excess film without scratching the glass, and then scrape the water between the glass and the film with a soft scraper. In order not to scratch the surface of the film, spray water on the surface of the pasted film, paste the torn plastic film, scrape the film flat with a scraper, and finally tear off the plastic film to complete the whole film pasting process;

5. Step 5: Wipe the water mark left in the corner of the window with deerskin.

Million car purchase subsidy