Many manufacturers neglected the problem of deformation when assembling melamine die-pressing doors. Doors cut corners and are still produced according to the simplified process of PVC doors, which leads to easy deformation of die-pressing doors. The deformation of the door is mainly the material for assembling the door. After consulting many experts in the wood industry, our factory finally solved the industry problems, mainly from the following aspects.

Low temperature short time pressing

Die-pressing doors should be pressed at low temperature for a short time to avoid damaging the internal structure of high-density plates in door panels.

Door panel health care

Door panel maintenance: The pressed door panel should be shaped and maintained for 65,438 0 weeks under the condition of constant humidity, so that the stress in the panel can be completely released in front of the combined door (the same as the reinforced floor maintenance).

Door retaining structure combination

Structural combination of door stop: a 25MM flat multi-layer board is cut into 30MM strips, two of which stand upright on the side.

Long-term cold-pressed embryo formation

It takes a long time to cold press the embryo, and the glue can not be demoulded until it is completely cured. It is best to use fast-curing glue.

The storage warehouse should be horizontal.

During storage in the warehouse, it should be placed vertically or horizontally, and the square tray must be absolutely horizontal.