First, the purpose of hair root positioning ironing: to increase the fluffy degree of hair roots; Improve the top contour of hairstyle; Adjust the flow direction of the modified hair root.
Second, the operating principle of hair root positioning perm: small-scale capacity adjustment of local or whole hair roots to achieve the purpose of increasing hair volume and creating a fluffy feeling.
Third, the type of hair root positioning perm: 1, braiding method: braiding hair roots with three hands, the length is about 2 ~ 3 cm, and perming. 2, knot method: tie a knot at the root of the hair, and then perm. 3. Single curling method: the hair is wound on a curling core with a diameter of 0.4 ~ 0.6 cm from the hair root for perm. 5. Direct connection method: firstly, the hair root is wound with a small winding core for 2-3 times, and then the hair tail is wound on a large winding core, which can produce a big wave effect of fluffy hair root. 6. Indirect connection method: firstly, part of the hair is separated as required, then another part of the hair is wound around a small winding core for 2-3 times, and finally, the hair ends of the two parts of hair are wound together on a large winding core for fixing, and then the hair is permed, which can produce fluffy and big wave effect.
Fourth, the hair root patch technology: For the long hair that has been permed for 3 to 6 months, if it is permed again, the new hair of the hair tail and hair root after perming will have two different curling effects, which will affect the perm quality. The following is the hair root patch technique. Curl down from the end of the hair as needed until it is close to the new hair. Wrap a piece of plastic paper around the core and continue to roll down to the hair root. After all the curls are curled, apply the first dose, so that the first dose can only be absorbed by the hair roots and new hair, and the curled part of the hair tail can not be absorbed by the plastic paper, thus achieving the purpose of protecting the curls and perming the new hair.
1. haircut-it is required to cut Korean broken hair (emphasize layering and gradual breaking, but not too thin. The layers must be closely connected and not trimmed too short. The braiding part should pay attention to the meticulous layering of the hair tips. ) 2. After shampooing, gently dry it with a hair dryer, insert your fingers into the hair room and repeat it everywhere (never use a comb). Finally, take a proper amount of hair wax, rub it between your palms and gently grasp it irregularly on your hair for finger insertion-to make your hair textured. Use as little hair wax as possible in hair knitting, so the effect will be better (you don't have to perm it, you can steal it back after going to the barber shop twice). The answer is Liu Hai 2/8, which is actually very simple. If you go to the barber's, tell the barber to cut your hair layer by layer to the right neck, then buy hair wax or gel water (I recommend hair wax) and get up every day or before going out.